600 Crosman Valve Rebuild Kit

COMPANY INFO

Home > REBUILD PARTS >

Our Price: $38.00

Quantity in Stock:29

Product Code: CR600VAREKI

Qty:

Description

Valve Stem Rebuild components and all seals for Professional Rebuild of the Crosman 600. We use 100% Polyurethane seals so our guns DON'T Leak. Made in USA by Mac1. A propane torch can be very helpful to get the brass head to separate from the steel stem. The seal fits in the brass head and you use a 1/8" hole in a anvil to drive the head and seal onto the stem. It is a good policy to use a permanent thread locker in the brass head for insurance. Once the head is pressed together it can be trued and faced off to ready it for use. Heat the entire gun up to toasty when you first charge it so the seals will be supple and the pressure will be high. Making sure there is no damage to the valve seat where the seal sits is very important as the Mac1 seals are hard enough so you can leave the gun charged all the time. Getting it to seal initially can be impossible if there is any seat irregularity. Polishing the seat is often required to remove any scratches or abuse. If you use the parts that make for the most reliable repairs imaginable a DIY project can be the best investment you ever made in an airgun. Quality parts last. Your time is wasted when you use inferior parts. Does not include the steel stem. Brass head and seals only. You reuse the Factory steel stem.

Crosman Valve Stem Rebuild HowTo

Share your knowledge of this product. Be the first to write a review »