Benjamin Sheridan Gen II Brake

COMPANY INFO

Home > STEROID PARTS >

Our Price: $75.00

Quantity in Stock:159

Product Code: BESHGEBR

Qty:

Description

Mac1 designed and manufactured brake for Benjamin & Sheridan Pump Rifles. This will fit all years .20 or .22 cal and any .177 Cal after 1985. Different barrel lengths require plastic seal(s) and or o-ring provided to fit and seal(two plastic spacers and an o-ring are supplied). Front sight will need to be removed or heated and moved aft to clear the brake. All Racine Benjamin and all Sheridan rifles will be able to use the Williams peep or open sights still if the front sight is moved back.
This is for the more handy and is primarily made for Pro use. Fitment is via two part epoxy. The spacer glues to the barrel and tube(apply glue to barrel and tube only) for about 2" at the front of the gun so it has plenty of contact area and support. Installer will need to dry fit with the plastic seal(s) and/or o-ring to accommodate the various barrel lengths that were made. The spacer that glues to the barrel must not bottom on the front plug. It must bottom on the plastic seal or o-ring combination so it seals up and no glue can get into the barrel at the joint. It must be clamped down as well as pushed aft to make a seal while curing. The Brake glues onto the spacer with the glue being only applied on the spacer OD. Wipe off the excess epoxy and make sure there are no problems with the alignment before the glue cures. This should only be done to a gun that has had a recent front end freshen up as the Brake will need to be removed if there is any need to service the front end. Heat can allow the removal of the brake at any time.

Share your knowledge of this product. Be the first to write a review »